Toshiba e-STUDIO385S - Hole Punching

2 PRINTING FROM WINDOWS
118 Printing With Best Functions for Your Needs
 Stapling
You can staple sets of paper to exit from the equipment.
Stapling is not available if a Finisher is not installed.
Stapling the paper
1
Display the [Finishing] tab menu.
2
Select the [Staple] position.
Upper Left — Select this to staple the printed document at the upper left.
Upper Right — Select this to staple the printed document at the upper right.
Center Top — Select this to double-staple the printed document along the top edge.
Middle Left — Select this to double-staple the printed document along the left side.
Center Double — Select this to fold and double-staple the printed document in the center.
 The selectable options vary depending on the model, paper size, and orientation.
 [Center Double] can be selected only when the Saddle Stitch Finisher is installed and configured
on the [Device Settings] tab.
3
Set any other print options you require and click [OK].
4
Click [OK] or [Print] to send the print job.
The output is stapled for each copy.
 Hole punching
Select this to punch holes on printed sheets of paper to exit from the equipment.
Hole punching is not available if a Hole Punch Unit is not installed.
Punching holes
1
Display the [Finishing] tab menu.
2
Select the [Hole Punch] position.
Middle Left — Select this to punch holes along the left side.
Center Top — Select this to punch holes along the top edge.
3
Set any other print options you require and click [OK].
4
Click [OK] or [Print] to send the print job.
Holes are punched.