2.PRINTING FROM WINDOWS
Printing With Best Functions for Your Needs 133
2 PRINTING FROM WINDOWS
Switching equipment to print jobs
When more than one piece of e-STUDIO Series equipment exists over a network, you can switch it to another
one on the printer driver menu.
If the equipment that you intended to use is busy with a large number of print jobs, for example, you can send
your job to another piece of e-STUDIO Series equipment that is currently holding no print jobs and have it
printed.
Switching equipment to print jobs
1
Display the [Others] tab menu.
2
Click [Output Devices].
The [Output Devices] dialog box appears.
3
Select [Print Job to Selected Devices].
4
Select the desired equipment in the [Selected Devices] boxes.
You can select more than one piece of equipment in the [Selected Devices] boxes. In this case,
the same number of copies is printed from all of the pieces of equipment you selected.
When you select the equipment in the [Selected Devices] boxes, make sure to select that which
supports features enabling all the print options of the job.
- Select equipment which enables stapling if the job needs that.
- Select equipment which enables hole punching if the job needs hole.
- Select equipment with the External Large Capacity Feeder installed if the job needs it.
- Select color equipment if the job needs full- or twin-color printing.
If you select the [Always Use This Setting] check box, you can omit the setting of the [Output
Devices] dialog box from the next time.
Equipment selected in the [Selected Devices] boxes must be registered in [Printer Folder]. If you
want to use equipment not registered in [Printer Folder], add it in [Add Printer] on the [Others] tab
of printer driver.
P.82 “Add Printer”
5
Click [OK] to close the [Output Devices] dialog box.
6
Set any other print options you require and click [OK].
To Next Page
Loading...
