2.OPERATIONS WITH THIS EQUIPMENT
16 Printing Documents
5
Change the print settings as necessary.
You can operate the print settings as below. Perform the appropriate operations. These operations of settings are
the same as the one of copy modes. For details of the operation, refer to the Copying Guide.
1. Select the paper feeder. However, if the selected paper size is different from the actual one, the selection will
be canceled and automatic paper selection will be applied.
2. Key in the number of copies to be printed.
3. Select the duplex printing mode. If you do not want to print on both sides of the paper, select [1 Side] in the
menu.
4. Select the finishing mode. The available finishing modes differ depending on the type of finishing device
installed.
5. Select the receiving tray. This button is available only when the Finisher (optional) is installed.
6. Set the position and width of the margin.
7. Set the position of the date and time to be printed.
8. Set the position of the page number to be printed.
6
Press [Print].
If you want to delete a job to cancel the printing, see the following section.
P.26 “Canceling jobs”
To Next Page
Loading...
