1.TROUBLESHOOTING FOR THE HARDWARE
94 Cleaning the Inside of the Equipment
2
Pull out the cleaner until the mark appears and return it. Repeat this 3 times for each unit.
The cleaner cannot be removed by design. Pulling it out forcibly may cause malfunction.
When only the main chargers need to be cleaned, steps 3 to 10 are unnecessary. Proceed to step 11.
3
Put your fingers in the waste toner box front grooves and take it out toward you pushing down
the top latch.
4
Place the waste toner box on a large sheet so as not to dirty the floor.
Do not place the waste toner box with its collecting port face down.
The waste toner may spill out from the box's collecting port.
5
Take out the green cleaner inside the cover.
To Next Page
Loading...
