1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 25
1 TROUBLESHOOTING FOR THE HARDWARE
7
Close the automatic duplexing unit cover.
Paper misfeed in the Bridge Kit
3
Close the Bridge Kit cover.
Paper misfeed in the Finisher and the Hole Punch Unit
Paper misfeed in the upper receiving tray
6
When the finisher is installed, close the Bridge Kit
cover.
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right side is
caught by the fuser unit, follow the steps on P.23 “Paper misfeed
in the fuser unit”.
1
Raise the lever and open the upper receiving tray of
the finisher.
2
1
To Next Page
Loading...
