1.TROUBLESHOOTING FOR THE HARDWARE
20 Clearing a Paper Misfeed
If paper misfeeds occur frequently
The following are the common causes of paper misfeeds. If the problem persists, check for the following situations.
An unsuitable original is placed on the ADF.
Unavailable paper with the equipment is used.
Paper sizes are not consistent between the size in a drawer or the bypass tray and the size registered in the
equipment.
All the misfed paper has not been removed.
There is too much of a gap between the paper and the side or end guide in the drawer.
The amount of paper placed in a drawer exceeds the limit indicated on the side guide of the drawer.
Do not touch the fuser unit or the metal portion around it.
Do not touch the fuser unit or the metal portion around it when you
remove the paper misfed in the right side of the equipment. This could
burn you or the shock could cause you to get your hand injured in the
machine.
Do not touch the transfer belt.
When you remove the paper misfed in the right side of the equipment, be
sure not to touch the transfer belt. This could stain copy images.
13.82
13.
To Next Page
Loading...
