1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 41
TROUBLESHOOTING FOR THE HARDWARE
18
Close the Hole Punch Unit cover when it is installed.
19
Close the front cover of the finisher, and connect the finisher to the equipment.
Move the finisher slowly placing your hands on the positions shown in the figure.
Be careful not to let your fingers be caught between the finisher and the equipment.
This could injure you.
Receiving unit
Receiving tray
1
Remove the paper from the receiving tray.
2
Clear the paper misfeed in the bridge unit.
P.44 “Bridge unit”
To Next Page
Loading...
