Toshiba E-STUDIO5508A - Page 43

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Misfeed 43
TROUBLESHOOTING FOR THE HARDWARE
 Receiving tray lower cover
1
Separate the Finisher from the equipment.
1. Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2. Pull the lever to unlock the finisher.
3. Placing your hands on the positions shown in the figure, move the finisher slowly until it stops, and then open
the front cover of the finisher.
2
Using the handle under the receiving tray, open the cover and remove the paper.
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed