8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 5
E076 Other paper jam Tandem LCF media type mis-setting jam:
The media type setting of the tandem LCF
is incorrect.
P. 8-67
E090 Image data delay jam: Image data to be
printed cannot be prepared.
P. 8-67
E091 Motor-ON time-out jam: The equipment
does not operate normally because
abnormality occurred on an interface
between the SYS board and engine
firmware.
P. 8-68
E0A0 Image transport ready time-out jam: Image
data to be printed cannot be sent.
P. 8-69
E110 Paper misfeeding ADU misfeeding (Paper not reaching the
registration sensor): The paper which has
passed through ADU does not reach the
registration sensor during duplex printing.
P. 8-43
E120 Bypass misfeeding (Paper not reaching the
bypass feed sensor): Paper fed from the
bypass tray does not reach the bypass feed
sensor.
P. 8-43
E130 1st drawer misfeeding (Paper not reaching
the 1st drawer feed sensor): The paper fed
from the 1st drawer does not reach the 1st
drawer feed sensor.
P. 8-44
E140 2nd drawer misfeeding (Paper not reaching
the 2nd drawer feed sensor): The paper fed
from the 2nd drawer does not reach the 2nd
drawer feed sensor.
P. 8-45
E150 3rd drawer misfeeding (Paper not reaching
the 3rd drawer feed sensor): The paper fed
from the 3rd drawer does not reach the 3rd
drawer feed sensor.
P. 8-45
E160 4th drawer misfeeding (Paper not reaching
the 4th drawer feed sensor): The paper fed
from the 4th drawer does not reach the 4th
drawer feed sensor.
P. 8-46
E180 Option LCF misfeeding (Paper not reaching
the LCF feed sensor): Paper fed from the
LCF does not reach the LCF feed sensor.
P. 8-46
E190 LCF misfeeding (Paper not reaching the
LCF feed sensor): The paper fed from the
LCF does not reach the LCF feed sensor.
P. 8-47
E200 Paper transport jam 1st drawer transport jam (Paper not
reaching the registration sensor): The
paper does not reach the registration
sensor after it has passed the 1st drawer
feed sensor.
P. 8-50
E210 2nd drawer transport jam (Paper not
reaching the registration sensor): The
paper does not reach the registration
sensor after it has passed the 1st drawer
feed sensor.
P. 8-50
Error code Classification Contents Troubleshooting
To Next Page
Loading...
Need help?
General
