To Next Page

To Previous Page

ERROR CODE and TROUBLESHOOTING

8 - 97

[EAE0] Receiving time-out jam

[EB30] Ready time-out jam

Check item Measures

Power • Check if the error is cleared by turning the power OFF and

then back ON.

SYS board • Connector check

• Board check

LGC board • Connector check

• Board check

Replace parts Remarks

SYS board

LGC board

Classification Error item

Finisher jam The printing has been interrupted because of the

communication error between the equipment and finisher

when the paper is transported from the equipment to the

finisher.

Check item Measures

Finisher • Is the finisher working?

• Check if the voltage (24V) is being supplied to the finisher.

Finisher controller board • Connector check

• Board check

Replace parts Remarks

Finisher controller board

Classification Error item

Finisher jam The equipment judges that the paper transport to the finisher

is disabled because of the communication error between the

equipment and finisher at the start of printing.

Check item Measures

Finisher • Check if there is any paper in the equipment. Remove it if

there is.

Finisher controller board • Connector check

• Board check

LGC board • Connector check

• Board check

Replace parts Remarks

Finisher controller board

LGC board

Toshiba E-studio5540c Service Manual

Other manuals for Toshiba E-studio5540c