1.GENERAL PRECAUTIONS
General Precautions 23
Other points
y If there is insufficient space around the equipment, the poor ventilation will result in malfunction, also
some operations such as bypass feeding and releasing paper jams may become difficult. To ensure
adequate space, follow the table below as a guide.
*1 When the finisher is installed, a space of approx. 80 cm (31.5") from the left edge of its exit tray is needed.
*2 Space from the left edge of the exit tray of the equipment
*3 Space from the right edge of the automatic duplexing unit
y Be sure to fix the power cable securely so that no one trips over it.
y Adverse environmental conditions may affect the safe operation and performance of the Multifunctional
Digital Systems, and the Multifunctional Digital Systems could break down.
- Avoid locations near windows or with exposure to direct sunlight.
- Avoid locations with drastic temperature fluctuations.
- Avoid too much dust.
- Avoid locations that suffer from vibration.
y Make sure that the air is able to flow freely and that there is sufficient ventilation.
Without adequate ventilation, the unpleasant odor released by ozone will begin to dominate the
atmosphere.
When using the Multifunctional Digital Systems
y Do not take off the cover of the equipment; otherwise you could be injured or get an electric shock.
y Do not remove or connect the plug with wet hands, as this could give you an electric shock.
y Do not place any container with liquid (flower vases, coffee cups, etc.) on or near the equipment.
This could cause a fire or give you an electric shock.
y Keep paper clips and staples away from the air vent. If not, a fire could result or you could get an electric
shock.
y If the Multifunctional Digital Systems becomes excessively hot, smoke comes out of it or there is an odd
smell or noise, proceed as follows.
Turn the main power switch OFF and remove the plug from the outlet, then contact your service
representative.
y If the Multifunctional Digital Systems will not be used for more than one month, remove the plug from the
outlet for safety purposes during that time. If an insulation failure occurs, this could cause a fire or give
you an electric shock.
y Do not place heavy objects (4 kg/9 lb. or more) on the original glass and do not press on it with force.
Breaking the glass could cause personal injury.
y Do not place heavy objects (4 kg/9 lb. or more) on the Multifunctional Digital Systems. If the objects fall
off, this could cause injury.
y Do not touch the fuser unit or the metal area around it. Since they are very hot, you could be burned or
the shock could cause you to injure your hand in the machine.
y Be careful not to let your fingers be caught when closing the drawer. This could cause an injury.
y Be careful not to let your fingers be caught between the equipment and the duplexing unit or automatic
duplexing unit. This could cause an injury.
Model
Adequate space
Rear Left Right
e-STUDIO5540C/6540C/6550C 10 cm (3.9")
30 cm (11.8")
*1, *2
50 cm (19.7")
*3
e-STUDIO2040C/2540C/3040C/3540C/4540C
e-STUDIO206L/256/306/356/456, e-STUDIO256SE/
306SE/356SE/456SE, e-STUDIO506/506SE
e-STUDIO556/656/756/856, e-STUDIO556SE/656SE/
756SE/856SE, e-STUDIO306LP
10 cm (3.9") 30 cm (11.8") 80 cm (31.5")
To Next Page
Loading...
Need help?
General
