Restores the previous working environment more rapidly than the
Hibernation Mode feature.
Saves power by shutting down the system when the tablet receives no
input or hardware access for the time period set by the System Sleep
Mode feature.
Executing Sleep Mode
You can enter Sleep Mode in one of following ways:
In the Settings charm, tap Power and then select Sleep.
Press the power button. Please note that this feature must be enabled
within the Power Options.
When you turn the power back on, you can continue where you left off
when you shut down the tablet.
Sleep Mode limitations
Sleep Mode will not function under the following conditions:
Power is turned back on immediately after shutting down.
Memory circuits are exposed to static electricity or electrical noise.
Hibernation Mode
The Hibernation Mode feature saves the contents of memory to the internal
storage when the tablet is turned off so that, the next time it is turned on,
the previous state is restored. Please note that the Hibernation Mode
feature does not save the status of any peripheral devices connected to the
tablet.
Save your data. While entering Hibernation Mode, the tablet saves the
contents of memory to the internal storage. However, for safety sake,
it is best to save your data manually.
Data will be lost if you disconnect the AC adaptor before the save is
completed.
Automatic Hibernation Mode
The tablet can be configured to enter Hibernation Mode automatically when
battery power is exhausted to the point that tablet operation cannot be
continued. This can be specified in the Power Options. In order to define
this setting, you can follow the steps as described below:
1. Tap Desktop Assist -> Control Panel -> System and Security ->
Power Options -> Change when the computer sleeps -> Change
advanced power settings on the desktop.
2. Tap Low battery action or Critical battery action under Battery and
then select Hibernate from the list with the condition of On battery or
Plugged in.
User's Manual 2-10
To Next Page
Loading...
Need help?
General