Need help?Do you have a question about the Toshiba ESTIA A09-01P and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Type | Heat Pump |
| EER | 11.0 |
| Power Supply | 230V, 50Hz |
| Energy Efficiency Ratio (Cooling) | 11.0 |
Diagram showing the layout of electrical components and terminal blocks within the E Box.
Illustrates the terminal block layout for connecting outdoor unit, hydro unit, and power supplies.
Details power supply requirements, maximum current, fuse rating, cable size, and connection points for power lines.
Specifies line type, max current, max length, cable size, and connection points for control wiring.
Step-by-step guide to setting function codes directly on the Hydro Unit for advanced configuration.
Instructions for setting function codes using the remote controller for system configuration and customization.
Defines the adjustable temperature ranges for heating (Zone 1/2), cooling, and domestic hot water.
Configures heat pump start and stop temperatures for hot water supply, recommended to use defaults.
Allows compensation of target temperature based on outside air temperature using a defined curve.
Configures the operation of a 2-way valve for cooling isolation, used with heating-only indoor units.
Step-by-step guide for performing a test run, including pump activation, pressure checks, and mode selection.
Guides on using outdoor unit LEDs to diagnose current faults by checking display modes.
Explains how to check past abnormal statuses using DIP switches and LED indicators on the outdoor unit.
To Next Page