183
11. Night time Low-noise Setting
•
•
1 Press the [
] / [
] button to select “Silent mode” on the
MENU screen, then press the [
] button.
2 Press the [
] button to select “ON” on the Silent mode screen,
then press the [ ] button.
3 Start the heating, cooling or hot water operation. The mark appears on the top screen during
the set-up time zone.
<How to enable, set start time and end time of night time low-noise>
•
1 Press the [
] / [
] button to select “Silent mode” on the
MENU screen.
2 Press the [
] button for 4 seconds or longer to enter the setting mode. The DN code setting
screen appears.
DN_0A: Start time (Range: 0-23, Default: 22)
0B: End time (Range: 0-23, Default: 06)
3 Press the [
] / [
] button to select DN or Data, then press the [
] / [
] button to set the
value.
The same value cannot be set to 0A and 0B.
4 Press the [ ] button. The set time is registered.
SET
ON
OFF
SET
Data
To Next Page
Loading...