156
6. Scheduled Operation Setting
6-1. How to set scheduled operation
• This function is available only for the header remote controller.
• Schedule setting makes the following modes to be flexibly set: hot water supply, heating, cooling, hot water
supply and heating, hot water supply and cooling, and stop, and set temperature.
• Set the unit clock and the schedule condition setting before schedule timer setting.
<Preparation>
Set the remote controller time at first.
Condition setting
• Up to 6 different running patterns per day can be programmed.
1 Press the [ ] / [ ] button to select “Setting” on the MENU
screen, then press the [ ] button.
2 Press the [ ] / [ ] button to select “Schedule setting” on
the setting screen, then press the [ ] button.
1 Press the [ ] / [ ] button to select “Condition setting” on the
Schedule setting screen, then press the [
] button.
2 Press the [ ] button to select the day, then press the [ ] button
to input running pattern.
3 Press [ ] / [ ] button to select the change item, then press the
[ ] / [ ] button.
Anti bacteria
MENU(2/2)
Frost protection
Setting
Information
SET
Power consumption
Initial setting
Setting
Schedule setting
SET
Condition setting
Schedule setting
Holiday setting
SET
Key lock
-- -- -- -- -- : -- -- : --
-- -- -- -- -- : -- -- : --
-- -- -- -- -- : -- -- : --
Condition setting(1/2)
ALL
TUE WED THU FRI SAT SUN
Mode Start End
SETDAY
COPY RESET
Z1 Z2 HW
MON
55 45 - - 08:00 22:00
25 - - - - 23:00 - - : - -
- - - - 65 18:00 19:00
Condition setting(1/2)
FIX
RESET
COOL
HW
HEAT
ALL
TUE WED THU FRI SAT SUN
Mode Start EndZ1 Z2 HW
MON
To Next Page
Loading...
