PREFERENCE QPL Night
IPT Installation Manual July, 2013 2-5
QPL Night Queuing Restriction Level for Night mode. Value = 1~ 16 (default = 1)
Note: Refer to System feature; Day Night Service
LCR Group Least Cost Routing Group Number. Value = 1~ 16 (default = 1)
Dialing Progress Tone Type of Tone to hear after dialing LCR access code.
Tone Types: Dial Tone (Default), Entry Tone or Silence
Call Pickup The station privilege to activate Call Pickup. Permitted (Default), Group
Only, Not Permitted
Bearer Capability ISDN Bearer Capability the PSTN is expecting from non ISDN stations:
3.1kHz Audio (data and speech) or Speech
Important Notes:
1. Standard telephone type data devices (modems, G3-fax signals)
must be set for 3.1 kHz audio on ISDAN lines.
2. The IPedge Net network does not support 3.1 kHz (data and
speech), all standard telephone equipment must be set to
Speech if making calls calls on IPedge Net.
Possible values: Audio (Default) or Speech
Display DN This number will display on the LCD of telephones when calling, or when
called by, this station or VM port.
If this station is a member of a Hunt Group that has a Pilot Number and
Pilot Display Number set in Station > Station Groups, Group Type = Hunt
Group; select Pilot Number and Number to Display respectively, enter the
HG Pilot Display Number in this field.
This is necessary for proper operation of Hunt Groups, including
centralized Voice Mail, over IPedge Net.
Dial String of 1~ 5 digits
CESID E911 Calling Party Information identifier for this station (CESID).
Up to 16 digits (default = no data)
Emergency Call Group The Emergency call group that this station belongs to.
1 (default) ~ 128
To Next Page
Loading...
