PREFERENCE LCR PDN Code
2-8 IPT Installation Manual July, 2013
LCR PDN Code Enter the number of digits that determine when to send the LCR PDN
code. The PDN code is registered in the LCR Modified Digits Table.
Four digits or three digits (default = three)
Speaker OCA Enable or disable Speaker OCA on an IP telephone.
Enabled or Disabled (Default)
IP Phone Login Password This feature determines whether a password is required for phone login.
Enable: Applies a phone login password. Disable: No login password is
needed. This feature is used for both EMPA and for IP User Mobility as
well. If this value is set to Enable, a password is required in Security
Code.
Security Code Enter the EMPA password for this station. This security code is also the IP
Mobility Login password. 16 Characters Max
Transfer Registration This feature determines whether the DN will be able to be logged out and
logged into another IPT or SoftIPT at another location. If disabled, this DN
cannot be logged out remotely and log into another IPT/SoftIPT. If
enabled, this DN can be logged out remotely and logged into another IPT/
SoftIPT station. This parameter enables and disables IP User Mobility.
Station Connecting
Equipment
Not Applicable
Calling Name Type Not Applicable
Specified Caller ID Enable = Station Name is displayed after answered to Internal call.
Disable= Station Name is changed to DN number after answered to
internal call.
System Speed Dial
Supplement
Select whether System Speed Dial supplement for IP stations should be
enabled or disabled (Default.
SIP Inband Mode This parameter is for SIP station extensions only.
When set to “Enable”, SIP extension can transmit a DTMF signal to a
trunk while ringing the calling party.
SIP Channel Number This parameter is for SIP station extensions only. This sets the maximum
number of channels for a SIP station. If set to a value higher than the
limitations for the device, the station will still be limited to the maximum
number it was designed to handle. SIP call limits:
• Outbound: Max number of channels (multiplied by two)
• Inbound: Max number of channels
To Next Page
Loading...
