IPT Installation Manual July, 2013 4-3
The IPT will save the IP address of the IPedge server.
The IPT will register to the IPedge server.
In about five to 10 seconds the IPT will change to ready. The IPT is now
ready for use.
If the DN is not found in that IPedge server the telephone will restart then
look for another IPedge server.
Depending on network activity another display may be visible as the
telephone finds then, registers to the server.
The Server Not Found and Make Busy displays are status displays not
error messages.
When the IPT registers with the IPedge server the phone connects in
Make Busy mode then changes to ready.
If you see any of these displays do not touch the IP telephone. The
process will finish without intervention.
If the IP telephone is unable to locate a server to register on the screen
will display IP Address setting with no change. Allow two to three minutes
Registering to
Primary Server
Betty Rubble No, 2101
May 20 Monday 04:30
Trying Primary Server
SERVER NOT FOUND
Betty Rubble No, 2101
MAKE BUSY
To Next Page
Loading...
