EN-15
SETTING UP YOUR OVEN
TURNTABLE INSTALLATION
Cleaning the cooking compartment and putting the turntable in place.
For new installations, make sure all packaging and shipping tape has been removed from the
turntable shaft.
Before using the appliance to prepare food for the first time, you will need to put the turntable
in place correctly. You must clean the cooking compartment and accessories.
How to put the turntable in place:
1. Place the turntable ring assembly
③
into the recess in
the cooking compartment.
2. Place the glass tray
①
on the turntable ring
assemblies
③
.
Fit the raised, curved lines in the center of the glass
tray bottom between the three spokes of the shaft.
Make sure that the glass tray
①
engages in the
turntable shaft
②
in the center of the cooking
compartment floor. The rollers on the shaft should fit
inside the turntable bottom ridge.
• Never use the appliance without the turntable. Make sure that it is properly
engaged. The turntable can turn clockwise or anti-clockwise.
• Never place the glass tray upside down. The glass tray should never be
restricted.
• Both glass tray and turntable ring assembly must always be used during
cooking.
• All food and containers of food are always placed on the glass tray for cooking.
• Never restrict the movement of the turntable.
• If glass tray or turntable ring assembly cracks or breaks, contact your nearest
authorized service center.
1
2
3
NOTE
To Next Page
Loading...
Need help?
General
