Toshiba MW20F52 - VCR Recording; Recording a TV Program

WHEN REPLACING EEPROM (MEMORY) IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
3.
4.
5.
6.
7.
8.
9.
10.
11.
The unit will now have the correct DATA for the new MEMORY IC.
Table 1
1.
2.
Fig. 1
ADDRESS is now selected and should "blink". Using the UP or DOWN button on the remote, step through the ADDRESS
until required ADDRESS to be changed is reached.
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using UP or DOWN button until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 3 to 6 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
After the data input, set to the initializing of shipping.
Turn POWER on.
Press both VOL. DOWN button on the set and the Channel button (1) on the remote control for more than 2 seconds.
After the finishing of the initializing of shipping, the unit will turn off automatically.
Enter DATA SET mode by setting VOLUME to minimum.
Press both VOL. DOWN button on the set and the Channel button (6) on the remote control for more than 2 seconds.
ADDRESS and DATA should appear as FIG 1.
INIT 00 6F
POWER ON 0010
PLAY/REC 0003
ADDRESS DATA
6F 40 34 00 C3 DF 47 22 86 44
+0 +1 +2 +3 +4 +5 +6 +7 +8 +9
+A
+B +C +D +E +FINI
40 E3 52 03 02 00 48 00 F6
99 96 8B 9F B7 AA 91 B6 1A 0B
45 31 33 FF 00
D0 18 A6 01 86 6500
10
0F
15 4B 1F 54 83 B1
3D 08 37 16 27 30
30
20
88 89 88 FF FF40
00 00 23 FF FF FF 80 88 83
CD
0D
--- --- --- --- --- --- --- --- ---
---
---
05 08 0A 0B 0D50
1F 1F 1F 20 20
60
15 17 19 1B 1D
1D 1E
1E 1E10 12
21
22 22
22 23 23 23 24 2420 21
24 25 25 25 26
70
2B 2C 2D 2D 2E80
27 27 28
28 29 29 2A 2A 2B
26 26
35 36 37 38 38 39 3B 3C 3F30 32
C4-1