_ji!_¸¸__i!!i_i_
Timer recording can be programmed on-screen with the remote control.
The built-in timer allows automatic unattended recording of up to 8
programs within I month.
.......................................................TV/VCR
-- TIMER REC
MENU
l
i i/
ENTER
÷
Preparation:
• Press TVNCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
oCheck the time and date are correct [_.
Example:
Program a timer recording for 23rd day, channel 125
(Cable TV), 7:00 - 9:30 PM (Tape speed : SLP).
Press MENU, then press _ or _'_ to select []
option.
L
MENU
O
Press t or [ to select "TIMER REC SET", then
press "_.
iiiiiiiiiiiiiiii,
Press t or _,to select one of the program _ine,
then press ENTER.
Press 4,_ or _ to select the date, then press _..
END --:--
Set the start time, end time, channel and tape
speed as in step 4.
Then press ENTER.
/ ..../
E_ID _:30PM
i!!:i t .....,,............o
g
Notes:
, Press _ to move cursor backward
for correction.
• To record from external source set
the channel to 'LI" or "L2".
To set the timer for another program, repeat
steps 3 to 5 to set another program.
Press both Tt_ER REC at the same time. The
T_ER REC indicator will light. The Timer is
programed, when the programed time is
reached, the recording is automatically
started.
TIME REC
_ \ _,, To cancel timer recording, press
O"_O_ ¢_ both the buttons again and TIMER
,* _\ REC indicator wilt go out.
Notes:
• The VCR section cannot be used while the TIMER REC in-
dicator is tit. If you want to use the VCR operation,press both
TIMER REC buttons at the same time to deactivate the timer.
• When the clock is not set, you cannot setect "TIMER REC'.
In this case, set the clock (see pages 19_21 ).
• After a power failure or disconnection of the power plug,all
programmed recording setting and time display will be lost
upon resumption of power. In this case, reset the ctock (see
pages 19_21) and reprogram any timer recordings.
• If you want to correct the digits while setting, press t or
until the item you want to correct, then press _ or "_ to
correct the desired setting.
• If programming is performed without a tape in the unit, or
with a tape without an erase prevention tab, the Timer Re-
cording is not possible. If a tape without an erase prevention
tab is in the unit, the tape wilt be ejected.
÷
40 _ 20/4/04.16:07
To Next Page
Loading...
