Toshiba MW24FP1 - Page 42

a video tape
If you connect the unit to another VCR or Camcorder, you can
duplicate a previously recorded tape. Make all connections before
turning on the power.
....................... TV/VCR
6 Jl
ii
ii
3
-sToP
1
÷
Duplicating a video tape
Preparation:
oPress TV/VCR to select the TV/VCR mode.
• Load a cassette tape with the erase prevention tab
intact.
• Load a previously recorded tape into the playback
VCR or Camcorder.
Press SP/SLP to select the desired tape speed
SP or SLR
SP_SLP tt iS recommended that you set the
(_ Speed to the SP mode on the
RETURN recording VCR for best results.
Press mNPUT SELECT once or twice to select
AUDIO!VIDEO input position.
"LINE1" or "LINE2" will appear on the
screen.
INPUT
SELECT
ZOOM
LINE1: on the rear panel
LtNE2: on the front panel
Press both REC at the same time.
r_ OREC ===a
O0
Press PLAY on the playback VCR or camcorder.
Press STOP after duplicating a video tape.
5@
Note:
Unauthorized recording of copyrighted television programs, films,
video cassettes and other materials may infringe the rights of
copyright owners and be contrary to copyright laws.
Connection with second video recorder
• Select "LINE1" on step 2.
P_ayback VCR
I! o
_ 0
III IJ
ToVIDEO OUT_ _{_ ToAUDIO (R) OUT
Audio/Video cable (not supplied) T _ ToAUDIO (L) OUT
RecordingVCR
\To AUDIO (R) IN
Connection with Camcorder
• Select "LINE2" on step 2.
Playback Camcorder
Recording VCR
jj .................................................................._
To AV Jack
mustration of MW20FP1
_ o AUDIO (R) IN
AUDIO (L)IN
To VIDEO IN Audio/Video cable (not supplied)
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer's
instructions. A typical camcorder dubbing hookup is
shown above.
÷
42 _ 20/4/04.16:07