27. LASER BEAM
Do not look into the opening of the disc tray or ventilation opening of the product to see the source of the
laser beam. It may cause sight damage.
28. D_SC
Do not use a cracked, deformed, or repaired disc. These discs are easily broken and may cause serious
personal injury and product malfunction.
29. NOTE TO CABLE TV SYSTEM _NSTALLER
This reminder is provided to call the Cable TV system installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con-
nected to the grounding system of the building, as close to the point of cable entry as practical.
EXAMPLE OF ANTENNA GROUNDING AS PER THE
NATIONAL ELECTRICAL CODE
=_
&
o
ANTENNA LEAD
IN WIRE
GROUND
÷
NEC-NATIONAL ELECTRICAL CODE
82898A
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810o20)
GROUNDING CONDUCTORS
(NEC SECTION810-21)
GROUND CLAMPS
__ POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
÷
IMPORTANT RECYCUNG INFORMATION
This product uses both Cathode Ray Tube (CRT) and other components that contain lead. _n
your community there might be regulations that require you to dispose these materials
property under env{ronmenta_ considerations. P_ease contact your Ioca_ authorities, or the
Electronic _ndustr{es AHiance (http:flwww.eiae.org) for disposa_ or recycling information.
AC Outlet
Wider Hole ___..
and Blade _
Polarized AC Cord Ptug
(One blade is wider than the other.)
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. insert the AC cord ptug
into a standard 120V 60Hz polarized AC outlet.
Notes:
• Never connect the AC line cord plug to other than the specified voltage (120V
60Hz). Use the attached power cord only.
• If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to
file or cut the btade. It is the useCs responsibility to have an electrician replace the
obsolete outlet.
• If you cause a static discharge when touching the unit and the unit fails to function,
simpty unplug the unit from the AC outIet and plug it back in. The unit should return
to normat operation.
• If the AC cord plug is pIugged in for the first time, wait for approx. 5 seconds before
pressing the POWER button.
5
5L00201C rE]p02-05 5 _ 20/4/04, 16:04
To Next Page
Loading...
Need help?
General
