Toshiba MW24FP1 - Page 63

÷
f SYMPTOMS CAUSE POSSIBLE SOLUTIONS IPAGE_
VCR
TV recording does not work.
Timer recording does not
work.
Noise bars appear on the
screen.
The video cassette's erase prevention tab
is broken off.
The time is not set correctly.
The recording start/end time is not set
correctly.
The TIMER REC buttons have not been
pressed at the same time (the TIMER
REC indicator is not tit).
Tape is old or worn.
Tracking adjustment is beyond range of
automatic tracking circuit.
Video heads are dirty.
Ptace a piece of adhesive tape over 33
the hole.
Reset the present time. 20, 21
Reset the start/end time.
4O
Press the TIMER REC buttons at the
same time (the TIMER REC indicator 40
is lit).
Replace the tape.
Adjust tracking manually using the TRK 35
+/- buttons on the remote control.
Clean the video heads. 37
DVD
The playback picture has
occasional distortion.
The unit does not start
playback.
Playback does not foItow the
course of the disc's program.
I_ appears on the screen.
REMOTE CONTROL
The disc is dirty.
tt is in fast forward or fast reverse
playback.
No disc is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
The parental lock function is set.
tt is in the mode of repeat playback,
memory playback, etc.
The function is prohibited with the unit or
the disc.
Eject the disc and dean it. 7
Some times a smalt amount of picture
distortion may appear. This is not a
malfunction.
Insert a disc. 44
Insert a piayabte disc (Check the disc
8
type and color system).
Place the disc with the playback side
44
down.
Place the disc correctly inside the
44
guide on the disc tray.
Clean the disc. 7
Cancel the parental lock function or
change the parental lock tevet. 58, 59
These operations may prevent a
proper progress of the contents.
8
The remote control is not aimed at the Aim the remote control at the remote
sensor, sensor.
Distance is too far or too much light in the Operate within 5 m or reduce the light
Remote controt does not room. of the room.
operate. There is an obstacte in the path of the Clear the path of the beam.
beam.
The batteries are weak. Replace the batteries.
12
12
12
12
The batteries are not inserted correctly. Insert correctly. 12 _
o
¢#
÷
63
5L00201C [E]p60-64 63 _ 20/4/04, 16:09