1. Install the SM card with calibration code into camera.
2. Place camera into the positioning fixture. The calibration
distance between camera lens and the surface of DNP light box
should be 40 ±1 cm and should be at the middle position.
3. Attach camera to power supply and TV cable.
4. Turn on the camera. TV displays “COMTOOL COMMAND
MENU”
5. Select Item 2 by using Zoom key (T/W)
6. Press shutter to run Near focus calibration.
7. If TV displays “OK” after calibration, camera is successfully
calibrated. If TV displays error code, camera fails.
3-4 Far Focus Verification
Tools:
Far Focus Chart
AC Adapter
SM Card with Calibration Code
Camera Positioning Fixture
45 cm Focus Target - attached to Light Box
TV cable, TV set
Procedure:
1. Install the SM card with calibration code into camera.
2. Place camera into the positioning fixture. The calibration
distance between camera lens and the target chart should be
45 ±1 cm and should be at the middle position.
3. Attach camera to power supply and TV cable.
4. Turn on the camera. TV displays “COMTOOL COMMAND
MENU”
5. Select Item 3 by using Zoom key (T/W).
6. Press shutter to run far focus calibration.
7. If TV displays “OK FOCUS OK” after calibration, camera is
successfully calibrated. If TV displays error code, camera fails.
3-5 Strobe Check
Tools:
Black Box: D90cm * W40cm * H40cm
AC Adapter
SM Card with Calibration Code
Positioning Fixture
90 cm 18% gray chart - attached to Black Box
TV cable, TV set
Procedure:
1. Install the SM card with calibration code into camera.
2. Place camera into the positioning fixture. The calibration
distance between camera lens and the black box should be 90
±1 cm and should be at the middle position.
To Next Page
Loading...
