Toshiba PDR-M25 - Description; Disassembly;Assembly Operation Steps of Disassembly

6
Section 2-1. Disassembly
Step Figure Description Remark Tools
1 Finished Product
l Examine if there's any
scratch on the surface.
2

Stick the mode knob
cap (93134-034) by
acrylic bar and pull up
the cap.
l Check if the stickiness of
acrylic bar is strong
enough to remove the cap
or not.
Acrylic
bar
3
Remove the screws
01635-117*2 and
95234-008 of mode
knob to detach the
knob from the camera

Screw
driver
4
Remove all the screws
of 01635-018*6 &
01635-290*1 at the
camera housing.
l
Do not scratch the camera
surface while removing
the screws.
Screw
driver
5
Detach the front cover
95234-420 from
camera then discharge
the Flash PCB.
l Discharge the FLASH
PCB