Toshiba PDR-M25 - Operation Steps of Assembly

10
Section 2-2. Assembly
Step Figure Description Remark
Tools
1
Install the lens to the
holder
2
Drive screws
01635-177*4 to fix
the lens set on core
l Do not touch the blades
while removing the
screws from the lens at
the star marked..
Screw
driver
3
Drive screws
01635-177*2 to fix
POWER PCB
Screw
driver
4
Insert the lens FPC
cable into the MCU
connector to as
semble
the MCU PCB (solder
the black wire as the
ESD solution)
l Watch out the direction of
FPC cable.
l The cable should be bent
as shown.
l Make sure the
connections of POWER &
MCU SW are correct.
5
Drive screws
01635-177*2 &
01635-287 to fix
MCU PCB
 
Screw
driver
6

Drive screws
01635-177*2 of
FLASH PCB
l The big capacitor should
be positioned in the circle
as shown
Screw
driver