196 Q9 ASD Installation and Operation Manual
User Notification Codes
The User Notification codes are displayed as an indication that a system function or system condition is
active. Table 10 lists the user-notification codes of the Q9 ASD. The code is displayed on the EOI for the
duration of the activation.
Table 10. User Notification Codes.
EOI Display Fault Description Possible Cause
ASD Type Error ASD Type Error.
• Firmware information (typeform) loaded into the
Application Board is inconsistent with the
typeform information loaded into the Motor
Control Board.
• Application Board or Motor Control Board is
defective.
Autotune Active Autotune Active.
Autotuning Err
Autotuning Error Except Etn1, Etn2, or
Etn3.
• Autotune readings are inconsistent with the
configuration information.
• Non-3-phase motor is being used.
• Improper settings at F400 or F410 – F413.
• Using a motor that has a significantly smaller
rating than the ASD.
• ASD output cabling is too small, too long, or is
being housed in a cable tray with other cables
that are producing an interfering EMF.
• Motor is running during the Autotune function.
Leak Inductance Err Autotuning Error — Leak Inductance Error. • Improper setting at F412.
Motor Rating Err Autotuning Error — Motor Rating Error. • Improper setting at F405, F406, or F407.
No error No Error.
Torque Boost Err Autotuning Error — Torque Boost Error. • Improper setting at F410.
To Next Page
Loading...
