Need help?Do you have a question about the Toshiba Q9+ and is the answer not in the manual?
Details about the manual's creation, purpose, scope, and copyright information.
Outlines the manual's content covering installation, operation, maintenance, and disposal of the ASD.
Emphasizes reading and understanding all safety information before operating the equipment.
Defines qualifications and responsibilities for personnel installing, operating, and maintaining the ASD.
Provides guidelines for safely moving, storing, and handling the ASD equipment.
Important considerations before connecting the ASD and motor to electrical power.
Instructions for connecting the 3-phase input power and output terminals to the ASD.
Guidelines for proper grounding to prevent electrical shock and reduce electrical noise.
Describes how to use the EOI for monitoring system functions and inputting data.
Details the functions of the LED screen, LCD screen, and rotary encoder.
Explains how to navigate menus and change parameter settings using the LCD screen.
Assists with initial configuration of ASD control settings, motor ratings, and display units.
Step-by-step guide to running the motor using the EOI in Local mode.
Describes how to change default parameter settings using the Program menu.
Establishes the primary source for command inputs like Stop, Run, and Jog.
Establishes the primary source for frequency-control input for the ASD.
Describes the three primary modes accessible via the Mode key: Frequency Command, Monitor, and Program.
Details how to set the running frequency of the motor from the Frequency Command screen.
Provides quick access to menu parameters like Direction, Stop Pattern, and V/f Group.
Sets system response to feedback from the V/I terminal for Direct or Process modes.
Establishes the lower level of the Auto Start-Stop threshold for Virtual Linear Pump operation.
Provides direct access to motor control functions via Program menu paths or parameter numbers.
Introduces variable speed AC motor control concepts relevant to the Q9 Plus ASD.
Information on using the Q9 Plus ASD with motors of significantly larger capacity.
Lists alarm codes, descriptions, and possible causes for system operating limits.
Explains ASD responses to faults, including disabling the system and removing 3-phase power.
Details fault codes displayed on the EOI and their possible causes.
Explains the convention for ASD part numbers and enclosure dimensions for model identification.
Provides enclosure dimensions and mounting hole details for 230-Volt Q9 Plus ASDs.
Lists standard ratings including output current, input voltage, and motor HP for 230-Volt ASDs.
Details wire/cable size, lug size range, terminal board wire size, and torque for 230-Volt ASDs.
Provides recommendations for circuit breaker selection based on ASD voltage and HP rating.
To Next Page
General
