Toshiba Q9+ - Program Mode Menu Navigation

Program Menu Navigation
Q9 Plus ASD Install/Op Manual
40 https://www.toshiba.com/tic/
Program Mode Menu Navigation
The following table lists the menu items of the Program mode and maps the flow of the menu selections.
The Parameter Numbers for the listed functions are provided where applicable.
The functions listed may be viewed, or selected and changed as mapped below or via the Direct Access
method: Program  Direct Access 
Applicable Parameter Number .
Program Mode Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
VIRTUAL LINEAR
P
UMP
(see Virtual Linear
Pump Setup on pg. 63
for more on this
function.)
Setup Wizard
Motor Rated Current (Nameplate)
F406
Application Type
F391
Command Source
F396
Low Frequency Limit
F398
Transducer Units N/A
Transducer Output Range (and Type)
F392
Transducer Maximum Reading
F393
Transducer Minimum Reading
F403
Virtual Linear Pump Maximum (Threshold)
F395
Set Virtual Linear Pump: Transducer Value N/A
Virtual Linear Pump Minimum (Threshold)
F394
Set Virtual Linear Pump: Transducer Value N/A
Settings
Mode Switch
F390
Application Type
F391
Application Type (Operating) Mode
F380
Transducer Units N/A
Transducer Output Range
F392
Transducer Maximum Reading
F393
Transducer Minimum Reading
F403
Virtual Linear Pump Minimum (Threshold)
F394
Virtual Linear Pump Maximum (Threshold)
F395
Command Source
F396
Command Value
F397
Low Frequency Limit
F398
Start and Stop Points Start/Stop Mode
F385
Program