To Next PageTo Next PageWhy Toshiba RAC-WK1012ESCWRU doesn't start?
Your Toshiba Air Conditioner might not be starting due to several reasons: the wall plug may be disconnected (push it firmly into the wall outlet), the circuit breaker may be tripped (reset it), the power may be off (turn it on), or the unit was turned off and then on quickly (turn it off and wait 3 minutes before restarting).
Why air from Toshiba Air Conditioner does not feel cold enough?
If the air from your Toshiba Air Conditioner doesn't feel cold enough, it could be due to several reasons. The room temperature might be below 62°F (17°C), in which case cooling may not occur until the room temperature rises above this level. Also, the temperature sensor behind the air filter might be touching the cold coil; try to move it so it does not contact the cold coil. The compressor might be shut-off by changing modes; wait approximately 3 minutes and listen for the compressor to restart when set in the COOL mode. Finally, there might be obstructions blocking the outdoor intake/exhaust; clear any obstructions.
Why Toshiba Air Conditioner turns on and off rapidly?
Your Toshiba Air Conditioner might be turning on and off rapidly because of a dirty air filter restricting air flow (clean the air filter), or due to extremely hot outside temperatures (set the FAN speed to a higher setting).
What to do if water is dripping INSIDE when Toshiba RAC-WK1012ESCWRU Air Conditioner is cooling?
If water is dripping inside when your Toshiba Air Conditioner is cooling, it's likely due to improper installation. Tilt the air conditioner slightly to the outside to allow for water drainage.
What to do if Toshiba Air Conditioner is cooling, but room is too warm - NO ice forming on cooling coil behind air filter?
If your Toshiba Air Conditioner is cooling but the room remains too warm and there's no ice forming on the cooling coil, consider these possibilities: * The air filter might be dirty or restricted (clean the filter). * The temperature might be set too high (lower the temperature setting). * Air directional louvers might be positioned improperly (adjust louvers for better air distribution). * The front of the unit could be blocked by drapes, blinds, or furniture (clear any obstructions). * Open doors, windows, or registers might be allowing cold air to escape (close them). * The room itself may be too warm, needing more time to remove stored heat from walls, ceiling, floor and furniture (allow additional time).
What to do if Toshiba Air Conditioner is cooling, but room is too warm and ice is forming on cooling coil behind air filter?
If your Toshiba Air Conditioner is cooling, but the room is too warm and ice is forming on the cooling coil behind the air filter, it could be due to: * Outdoor temperature being below 64°F (18°C) - set to FAN ONLY mode to defrost the coil. * A dirty air filter - clean the filter and set to FAN ONLY mode to defrost. * Thermostat set too cold for night-time cooling - set to FAN ONLY mode to defrost the coil, then set the temperature to a higher setting.
Why is my Toshiba RAC-WK1012ESCWRU Air Conditioner making noise when cooling?
The noise you hear when your Toshiba Air Conditioner is cooling could be due to air movement sound; if it's too loud, set to a slower FAN setting. Alternatively, it could be window vibration due to poor installation.
Why is the room too cold when using my Toshiba RAC-WK1012ESCWRU?
If the room is too cold when using your Toshiba Air Conditioner, the temperature setting is likely too low. Increase the temperature setting.
Why does my Toshiba RAC-WK1012ESCWRU Air Conditioner make noise when it starts?
A “da-da” sound may occur for thirty seconds when the Toshiba Air Conditioner is turned on due to the compressor starting. It is normal.
Why is Remote sensing deactivating prematurely on my Toshiba Air Conditioner?
Remote sensing on your Toshiba Air Conditioner might be deactivating prematurely because the remote control is not located within 16.4 feet & 180°, radius of the front of the unit, and pointed in the general direction of the air conditioner unit (place it within range). It could also be due to an obstruction blocking the remote control signal (remove any obstructions).
General| Refrigerant | R32 |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Weight | 9 kg |
| Cooling Capacity | 10, 000 BTU/h |
| Outdoor Unit Noise Level | 50 dB(A) |
| Operating Temperature Range (Cooling) | 18°C to 43°C |
Explains how to set auto start and stop timer functions for the unit.
Instructions on placing the unit into the window opening and ensuring proper tilt for drainage.
Explains how to secure the air conditioner frame and side panels to the window.
Provides instructions on checking, cleaning, and maintaining the air filter for optimal performance.
Details how to clean the exterior cabinet and front panel of the air conditioner safely.
Provides instructions and precautions for using the remote control effectively.
Explains the function of each button on the remote control for operating the unit.
Explains basic operations like setting temperature, changing modes, and adjusting fan speed using the remote.
Details how to set the timer for automatic unit turn-on and turn-off.
Explains how to set the timer to automatically turn the unit on after a specified period.
Explains how to set the timer to automatically turn the unit off after a specified period.
Guides on setting both timer functions simultaneously for automated operation.
Explains advanced functions like SLEEP and ECO modes using the remote.
Details the sleep function for energy saving during nighttime operation.
Explains how to use the shortcut function to save and recall custom settings.
