To Next PageTo Next PageHow to fix a Toshiba RAC-WK1823ESCWRU Air Conditioner that won't start?
If your Toshiba Air Conditioner isn't starting, make sure the wall plug is firmly pushed into the outlet. Also, check the circuit breaker and reset it if it has tripped. If the light on the plug is off, press the RESET button. Ensure the power is turned ON, and try turning the unit off, waiting 3 minutes, and then restarting it.
What to do if Toshiba Air Conditioner is cooling, but room is too warm?
If your Toshiba Air Conditioner is running but the room isn't cooling down and there's no ice on the coil, try these steps: Clean the air filter, as a dirty or restricted filter can cause this issue. Set the temperature to a lower setting. Make sure the air directional louvers are positioned correctly for good air distribution. Clear any obstructions blocking the front of the unit, like drapes or furniture. Close any doors, windows, or registers. If the room is very warm, allow extra time for the unit to remove stored heat from the walls, ceiling, floor, and furniture.
Why is my Toshiba Air Conditioner not cold enough?
If the air from your Toshiba unit doesn't feel cold enough, it might be because the room temperature is below 62°F (17°C); cooling may not occur until the room warms up. Check if the temperature sensor behind the air filter is touching the cold coil and move it if it is. Try setting the unit to a lower temperature. Wait about 3 minutes to see if the compressor restarts in COOL mode. Also, check for and clear any obstructions blocking the outdoor intake/exhaust.
Why does my Toshiba Air Conditioner turn on and off rapidly?
If your Toshiba Air Conditioner is turning on and off rapidly, it could be due to a dirty air filter restricting airflow, so clean the air filter. If the outside temperature is extremely hot, set the FAN speed to a higher setting. Also, check for any obstructions blocking the outdoor intake/exhaust and clear them.
Why is my Toshiba RAC-WK1823ESCWRU dripping water outside?
If your Toshiba Air Conditioner is dripping water outside when cooling, it's likely because the unit is removing a large amount of moisture from a humid room. This is normal during very humid days.
Why is my Toshiba RAC-WK1823ESCWRU making noise when cooling?
Some air movement sound is normal during cooling. If it's too loud, try setting the fan to a slower speed. If you notice window vibration, it could be due to poor installation. Refer to the installation instructions or check with the installer.
Why is my Toshiba RAC-WK1823ESCWRU Air Conditioner dripping water inside?
If your Toshiba Air Conditioner is dripping water inside when cooling, it could be due to improper installation. Ensure the air conditioner is tilted slightly to the outside to allow for water drainage. Refer to the installation instructions or check with the installer.
Why does my Toshiba RAC-WK1823ESCWRU make noise when it starts?
A 'da-da' sound may occur for about thirty seconds when your Toshiba unit is turned on because of the compressor starting. This is normal.
Why is my Toshiba Air Conditioner cooling but the room is too warm and ice is forming?
If your Toshiba air conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, it could be due to several reasons. If the outdoor temperature is below 64°F (18°C), set the unit to FAN ONLY mode to defrost the coil. A dirty air filter can also cause this, so clean it. Additionally, if the thermostat is set too cold for nighttime cooling, set the unit to FAN ONLY mode to defrost the coil and then raise the temperature setting.
Why is the remote sensing deactivating prematurely on my Toshiba RAC-WK1823ESCWRU?
If the remote sensing is deactivating too soon on your Toshiba Air Conditioner, ensure the remote control is within 16.4 feet and 180° of the front of the unit, pointed towards it. Also, make sure there are no obstructions blocking the remote control signal.
General| Cooling Capacity | 18000 BTU/h |
|---|---|
| Energy Efficiency Ratio (EER) | 3.21 |
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Operating Temperature Range (Cooling) | 18-43°C |
Explains the meaning of WARNING, CAUTION, and NOTICE symbols used in the manual.
Crucial warnings regarding electrical safety, operation, and potential hazards.
Cautions related to power cords, grounding, and handling the unit to prevent injury.
Cautions for operating the unit, including placement and usage in specific environments.
Explains unit symbols and highlights safety concerning flammable refrigerant (R32).
Details the current detection device in the power cord and its safety functions.
Describes typical sounds like rushing air, high pitched, trickling, gurgle/hiss, and vibration.
Outlines the operating conditions and general features of the air conditioner.
Step-by-step guide to start operating the air conditioner for the first time.
Instructions on how to adjust louvers for desired airflow direction (left/right, up/down).
Explains the function of the fresh air vent for recirculating or drawing in fresh air.
Details the functions of buttons on the electronic control panel.
Explains the function of each button on the control panel (Timer, Sleep, Mode, etc.).
How to set auto start and auto stop timer features for the unit.
Explains what the display shows and lists common error codes and their solutions.
Important warnings and recommendations before starting the installation process.
Steps to check before performing the actual installation.
Guide to checking window size, condition, airflow, and electrical service.
Lists the hardware provided with the unit and necessary tools for installation.
Detailed steps for safely removing the air conditioner unit from its cabinet.
Steps for preparing the cabinet, including attaching gaskets and retainers.
Guide for placing and securing the main cabinet into the window opening.
Instructions for attaching support brackets to secure the unit.
Steps to extend and secure the accordion panels for proper fit.
How to install window sash seals and safety locks for a secure fit.
Final steps to insert the air conditioner unit back into the cabinet.
Guide for installing insulation for ENERGY STAR models to minimize air leaks.
Advice on how to handle installation if a storm window is present.
Steps for safely removing the installed air conditioner from the window.
Instructions on how to clean the air filter for optimal performance.
Guidance on how to clean the exterior of the air conditioner unit.
Steps for properly storing the air conditioner during the winter season.
Solutions for common problems like the unit not starting or weak cooling.
Addresses issues with ice formation on coils and poor airflow.
Solutions for problems like rapid on/off cycling, noise, and water dripping.
Troubleshooting steps for remote control malfunctions and Wi-Fi/App connectivity.
Guidelines for using the remote control effectively and its operating range.
Instructions on how to replace the battery in the remote control.
Details specifications and explains the function of each button on the remote.
Step-by-step guide to program the auto start and auto stop timer functions.
How to set both auto start and auto stop timers simultaneously.
Technical details of the wireless module used in the smart AC.
Precautions related to operating systems, network encryption, and connectivity.
Lists devices and requirements needed to use the Smart AC features.
Instructions on how to download and install the companion mobile app.
Steps for creating an account for the smart air conditioner app.
Information on accessing further app features and smart home capabilities.
