9
TOSHIBA RAS-07/10/13UKHP-E (US) 1075000801
EN
Start
11
11
1 START/STOP button
Press this button to start the air conditioner.
22
22
2 Mode select button (MODE)
Select DRY
33
33
3 Temperature button ( )
Set the desired temperature.
• The fan speed display indicates AUTO.
• The OPERATION lamp (green) on the display panel of the indoor
unit lights, and operation starts after approximately
3 minutes.
Stop
START/STOP button
Press this button again to stop the air conditioner.
DRY OPERATION
Start
11
11
1 START/STOP button
Press this button to start the air conditioner.
22
22
2 Mode select button (MODE)
Select Cool , Heat , or Fan only .
33
33
3 Temperature button ( )
Set the desired temperature.
Cooling 21°C or higher.
Heating 28°C or lower.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
44
44
4 Fan speed button (FAN)
Select one of “AUTO” LOW , LOW
+
, MED ,
MED
+
, HIGH
• The OPERATION lamp (green) on the display panel of the indoor unit
goes on. And operation starts after approximately 3 minutes.
(if you select FAN ONLY mode, the unit will start immediately.)
• The
: Fan only mode does not control temperature.
Therefore, perform only steps 1, 2 and 4 to select this mode.
Stop
START/STOP button
Press this button again to stop the air conditioner.
COOLING/HEATING/FAN ONLY OPERATION
PRESET
FAN MODE
Hi-POWER
ON
OFF SET CLR
ECO
AUTO
TIMER
CLOCK CHECKRESET
FILTER
START/STOP
1
3
1
3
FIX
MEMO
SWING
4
2
4
2
PRESET
FAN MODE
AUTO
ON
OFF SET CLR
ECO
Hi-POWER
TIMER
CLOCK CHECKRESET
FILTER
START/STOP
FIX
MEMO
SWING
1
2
3
1
2
3
01RAS-07/10/13UKHP_E P09-12 1/31/02, 4:24 PM9
To Next Page
Loading...
