– 33 –
8-6-2. Name and Functions of Indications on Remote Controller
[Display]
All indications, except for clock time indication, are indicated by pushing the START/STOP button.
6
TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
7
Hi-POWER display
Indicates when the Hi-POWER operation starts.
Push the Hi-POWER button to start and push it
again to stop the operation.
8
P
(MEMORY) display
Flashes for 4 seconds when the MEMO button is
pushed during operation.
P
mark is indicated when keeping the button
depressed for more than 2 seconds while the
mark is flashing.
Push another button to turn off the mark.
9
ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display
changes in the sequence of 1, 3, 5, or 9h.
1
Transmission mark
This transmission mark
indicates when the
remote controller transmits signals to the indoor
unit.
2
Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control,
: Cool, : Dry, : Heat,
: Fan only)
3
Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
: Fan only,
no temperature setting is indicated.
4
Louver operation display
Indicates the louver positioning and operation.
Five selectable positions
, , , ,
Automatic Swing .
5
FAN speed display
Indicates the selected fan speed. AUTO or one of
five fan speed levels (LOW
, LOW
+
,
MED
, MED
+
, HIGH ) can be
indicated.
Indicates AUTO when the operating mode is
either AUTO or
: Dry.
• In the illustration, all indications are indicated for explanation.
During operation, only the relevant indications will be indicated on the remote controller.
AUTOA
AM
PM
CHK
HiPOWER
ON
OFF
˚
C
:
AM
PM
:
P
AUTO
3
95
76
1
2
8
4
AUTO
OFF
PM
:
AUT
To Next Page
Loading...
