– 40 –
4. DRY OPERATION (COOLING ONLY)
For dehumidification, a moderate cooling performance is controlled automatically.
1. Press MODE : Select Dry .
2. Press TEMP : Set the desired temperature.
5. Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling operation
Press HI-POWER : Start and stop the operation.
(except in DRY and FAN ONLY mode).
6. POWER-SELECTION OPERATION
To select the limitation of maximum current/ power consumption.
Press POWER-SEL : Select: (for 100%), (for 75%), (for 50%)
7. TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
without using the remote control.
• Operation mode is set on AUTOMATIC
operation, preset temperature is 24°C
and fan operation is automatic speed.
8. TIMER OPERATION
Setting the ON Timer Setting the OFF Timer
Press
ON
: Set the desired ON timer.
Press
OFF
: Set the desired OFF timer.
Press
SET
: Set the timer. Press
SET
: Set the timer.
Press
CLR
: Cancel the timer. Press
CLR
Press
ON
: Set the ON timer.
Press
SET
.
Press
OFF
: Set the OFF timer.
Press
SET
button during the ( or )
mark flashing.
1
1
2
3
2
3
3
4
Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting daily Timer
· During the daily timer is activation, both arrows are indicated.
( or )
FILE NO. SVM-12053
Note:
· Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
· The setting will be saved for the next same operation.
Note : Due to the reason that POWER SELECT FUNCTION limits the maximum
currnet, inadequate cooling capacity may occur.
To Next Page
Loading...
