EasyManua.ls Logo

Toshiba RAS-18SK Series - Advanced Operations and Maintenance; Preset and Auto Restart; Quiet, Comfort Sleep, and Sleep Timer; Maintenance Procedures

Toshiba RAS-18SK Series
4 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PRESET OPERATION
14
Setyourpreferredoperationforfutureuse.Thesettingwillbememorizedbythe
unitforfutureoperation(exceptairowdirection).
1.Selectyourpreferredoperation.
2.Pressandhold
PRESET
for3secondstomemorizethesetting.ThePmark
displays.
3.Press
PRESET
:Operatethepresetoperation.
AUTO RESTART OPERATION
15
Toautomaticallyrestarttheairconditionerafterthepowerfailure(Powerofthe
unitmustbeon.)
Setting
1.PressandholdtheRESETbuttonontheindoorunitfor3secondstosetthe
operation.(3beepsoundandOPERATIONlampblink5time/secfor
5seconds)
2.PressandholdtheRESETbuttonontheindoorunitfor3secondstocancel
theoperation.(3beepsoundbutOPERATIONlampdoesnotblink)
IncaseofONtimerorOFFtimeareset,AUTORESTARTOPERATION
doesnotactivate.
Tooperateatsuperlowfanspeedforquietoperation(exceptinDRYmode)
Press
QUIET
:Startandstoptheoperation.
Note:Undercertainconditions,QUIEToperationmaynotprovideadequate
coolingorheatingduetolowsoundfeatures.
QUIET OPERATION
16
Forcomfortablesleep,automaticallycontrolairowandautomaticallyturnOFF.
Press
COMFORT
SLEEP
:Select1,3,5or9hrsforOFFtimeroperation.
Note: Thecoolingoperation,thesettemperaturewillincreaseautomatically
1degree/hourfor2hours(maximum2degreesincrease).Forheating
operation,thesettemperaturewilldecrease.
COMFORT SLEEP OPERATION
17
OPERATION AND PERFORMANCE
21
1.Three-minuteprotectionfeature:Topreventtheunitfrombeingactivatedfor
3minuteswhensuddenlyrestartedorswitchedtoON.
2.Preheatingoperation:Warmuptheunitfor5minutesbeforeblowingwarmair.
3.Warmaircontrol:Whentheroomtemperaturereachesthesettemperature,
thefanspeedisautomaticallyreducedandtheoutdoorunitwillstop.
4.Automaticdefrosting:Fanswillstopduringdefrostoperation.
5.Heatingcapacity:Heatisabsorbedfromoutdoorandreleasedintotheroom.
Whentheoutdoortemperatureistoolow,useanotherrecommendedheating
apparatusincombinationwiththeairconditioner.
6.Considerationforaccumulatedsnow:Selectthepositionforoutdoorunitwhere
itwillnotbesubjectedtosnowdrifts,accumulationofleavesorotherseasonal
debris.
7.Someminorcrackingsoundmayoccurwhenunit operating.Thisisnormal
becausethecrackingsoundmaybecausedbyexpansion/contractionofplastic.
Note:Item2to6forHeatingmodel
Air conditioner operating conditions
Temp.
Operation
Outdoor Temperature
Room
Temperature
Heating –10°C~24°C Lessthan28°C
Cooling 15°C~46°C 21°C~32°C
Dry 15°C~46°C 17°C~32°C
The unit does not operate.
Cooling or Heating is abnormally low.
Thepowermainswitchisturnedoff.
Thecircuitbreakerisactivatedto
cutoffthepowersupply.
Stoppageofelectriccurrent.
ONtimerisset.
Theltersareblockedwithdust.
Thetemperaturehasbeenset
improperly.
Thewindowsordoorsareopened.
Theairinletoroutletoftheoutdoor
unitisblocked.
Thefanspeedistoolow.

TheoperationmodeisFANorDRY.
TROUBLESHOOTING (CHECK POINT)
22
Tostartthesleeptimer(OFFtimer)operation
Press
SLEEP
:Select1,3,5or9hrsforOFFtimeroperation.
SLEEP TIMER OPERATION
18
REMOTE CONTROL A-B SELECTION
23
Toseparateusingofremotecontrolforeachindoorunitincaseof2air
conditionersareinstallednearly.
Remote Control B Setup.
1.PressRESETbuttonontheindoorunittoturntheairconditionerON.
2.Pointtheremotecontrolattheindoorunit.
3.Pushandhold
CHK
buttonontheRemoteControlbythetipofthepencil.
“00”willbeshownonthedisplay.
4.Press
MODE
duringpushing
CHK
.“B”willshowonthedisplayand“00”
willdisappearandtheairconditionerwillturnOFF.TheRemoteControlBis
memorized.
Note: 1.Repeatabovesteptoreset
RemoteControltobeA.
2.RemoteControlAhasnot“A”
display.
3.DefaultsettingofRemote
ControlfromfactoryisA.
PRESET
ONE TOUCH
QUIET
SWING
TIMER
ON
FILTER
CHECK
CLOCK
OFF
CLR
SLEEP
SET
FIX HI POWER ECO
PAP
COMFORT
SELECT
MODE
TEMP
FAN
SELF CLEANING OPERATION (COOL AND DRY
OPERATION ONLY)
20
Toprotectbadsmellcausedbythehumidityintheindoorunit.
1.Ifthe
buttonispressedonceduring“Cool”or“Dry”mode,thefanwillcontinue
torunforother20minutes,thenitwillturnoffautomatically.Thiswillreduce
themoistureintheindoorunit.
2.Tostoptheunitimmediately,pressthe
more2timeswithin30seconds.
Note:
SELFCLEANINGoperationisdefaultsettingfromfactory.
Tocancelthisfunction,pressandholdtheresetbuttonontheindoorunitfor
20seconds.
TheSELFCLEANINGoperationwillbecancelled.(5beepsoundbut
OPERATIONlampdoesnotblink)
Dothesametosetthisfunctionagain.(5beepsoundandOPERATIONlamp
blink5times/secfor5seconds)
AUTORESTARToperationwillbecancelledbysettingorcancellationof
SELFCLEANINGoperation.Setitagainifneccessary.
Firstly,turnoffthecircuitbreaker.
Filter Reset
FILTERlamplightson;theltermustbecleaned.
Toturnoffthelamp,pushtheRESETbuttonontheindoorunitortheFILTERbutton
ontheremotecontrol.
Indoor Unit and Remote Control
Cleantheindoorunitandtheremotecontrolwithawetclothwhenneeded.
Nobenzine,thinner,polishingpowderorchemically-treatedduster.
Cleaning the air ionizer (Once every six months)
1.Turnoffairconditionerusingremotecontrolandpowersupply.
2.Fullyopentheverticalairowlouversbyhand.
3.Useatoothbrushtorubtheendsofmetalpin
threeorfourtimes.
Note: Donotusecottonswabsorotherobjects
withuff.
Evenbefore6monthssincelastcleaning,
cleantheairionizerifitisdirty.
Cleaning the plasma air purier unit (About 1000 hours performed)
1.Turnoffairconditionerusingremotecontrolandpowersupply.
2.Takeouttheairinletgrille(Seedetailininstallationmanual).
3.Takeouttheplasmaairpurierbygraspthehandle,andthepullitout
4.Soakinhotwaterat40°Cto50°Cforabout10to15minutesandrubup,
down,left,rightandrubsurfacegentlywithasponge.
5.Allowtodrythoroughlyintheshade.
6.Attachtheplasmaairpurierbygraspthehandleand
insertintotherightandleftguiderails.
7.Pressbothendsoftheplasmaairpurieruntilthe
protrusionsonbothsidesoftheplasmaairpurier
arecompletelyinsertd.
8.Attachtheairlter,andthenclosetheairinletgrille.
MAINTENANCE
19

Related product manuals