– 52 –
10-3. Indoor Unit
10-3-1. Installation Place
• A place which provides the spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed as top of the indoor
unit comes to at least 2 m height. Also, it must be
avoided to put anything on the top of the indoor
unit.
CAUTION
• Direct sunlight on the indoor unit's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
10-3-2. Cutting a Hole and Mounting
Installation Plate
<Cutting a hole>
When install the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
installation plate (
ð
) drill the pipe hole
(∅ 65 mm) at a slight downward slant to the
outdoor side.
NOTE :
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
Fig. 10-3-2
m from the right side edge is
e center of pipe hole
35 120 180 240
23 mm
∅65 mm
The center of the pipe hole is above
the arrow
.
Pipe hole
Fig. 10-3-1
Fig. 10-3-3
FILE NO. SVM-13003
5
4 °
4
5°
5
7 °
(Top view)
Reception
range
Remote
control
Remote
control
(Side view)
Indoor unit
Indoor unit
Reception range
T
o
un
i
t
ou
t
l
i
n
e
2
4
0m
m
T
o
un
i
t
o
u
t
l
i
n
e
3
5
m
m
T
o
un
i
t
o
u
t
l
i
n
e
2
4
0m
m
Offset 23mm from the right side edge is
the center of pipe hole
T
o
u
n
i
t
ou
t
l
i
ne
12
0
m
m
0
2
3
3
5
1
2
0
1
8
0
2
4
0
Offset 85mm from the left side edge is
the center of pipe hole
170
170
5
0
40
8
5
13
2
23
∅ 6
5
mm
Hook
Hook
Hook
Pipe hole
Pipe hole (∅65 mm)
Weight
Indoor unit
Thread
2 m or more from floor
Anchor bolt holes
1 Installation plate
7 Mounting
screw
• A place where there are no obstacles such as a
curtain that may block the signal from the remote
control.
• Do not install the remote control in a place
exposed to direct sunlight or close to a heating
source such as a stove.
• Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
• The location of the remote control should be
determined as shown below.
To Next Page
Loading...
