Need help?Do you have a question about the Toshiba RAS-45SKVP2-ND and is the answer not in the manual?
General| Type | Split System |
|---|---|
| Cooling Capacity | 4.5 kW |
| Heating Capacity | 5.0 kW |
| Power Supply | 220-240 V, 50 Hz |
| Refrigerant | R410A |
| Outdoor Unit Weight | 32 kg |
Crucial safety precautions for handling R410A during installation and servicing tasks.
Step-by-step guide for safely recharging refrigerant into the system.
Diagram illustrating the flow of refrigerant and the function of key components in the cycle.
Block diagram of the outdoor unit's control system, including the inverter assembly.
Overview of the unit's control system architecture and operational principles.
Identification and explanation of all functions and indicators on the remote controller.
Visual guide showing the placement and clearances for indoor and outdoor unit installation.
Procedures for installing the indoor unit, including location selection and mounting.
Steps for preparing wall openings and mounting the indoor unit's support plate.
Instructions for safe and correct electrical connections and wiring.
Guidance on routing and insulating refrigerant pipes and drain hoses for proper function.
Detailed steps for physically mounting the indoor unit onto the prepared installation plate.
Instructions for setting up the drain hose and ensuring effective water drainage.
Guidelines for selecting an optimal and safe location for the outdoor unit installation.
How to correctly connect the power supply and control wiring to the outdoor unit.
Using the remote controller to access and interpret error codes for detailed self-diagnosis.
Important cautions and procedures to follow when using the service mode and after servicing.
Specific troubleshooting steps for check codes related to miswiring and discharge temperature errors.
Step-by-step guide for diagnosing problems specifically within the outdoor unit.
Procedures for replacing various parts within the indoor unit, starting with the front panel.
Procedures for replacing major components of the outdoor unit, including cabinets and assemblies.
Procedure for safely removing and installing the inverter assembly, including discharge precautions.
Procedure for replacing the control board assembly of the outdoor unit.
Procedure for removing and installing the compressor, including refrigerant handling.
To Next Page