– 112 –
No.
7
Part name
Pulse motor
valve coil
Procedure
1. Detachment
1) Perform work of item
1
and
2
.
2) Release the coil from the notch by turning it,
and remove coil from the pulse motor valve.
2. Attachment
1) Put the coil deep into the bottom position.
2) Fix the coil firmly by turning it to the notch
position.
The pulse motor valve has A, B, C and D
room side.
After mounting it, check that coil at A room
side (YEL marking is marked on the pulse
motor valve.) is connected to CN701.
Check that coil at B room side (Nothing is
marked on the pulse motor valve.) is con-
nected to CN702.
Check that coil at C room side (Red marking
is marked on the pulse motor valve.) is
connected to CN703.
Check that coil at D room side (Blue marking
is marked on the pulse motor valve.) is
connected to CN704.
Remarks
Hooking claw
Minus screwdriver
PMV coil
Lead wire
take-out port
ID mark
ID mark
Positioning bracket
at coil side
Positioning concavity
at PMV unit side
(72˚ pitch)
PMV unit
Mounting Method of
Pulse Motor Valve (PMV) Coil
Set the positioning bracket on
the PMV coil to a concavity at
PMV unit side and fix PMV coil.
In this time, match color of ID
mark at the coil side with that of
ID mark at the PMV unit side.
Make sure also that pipes do
not deform when inserting and
fixing the coil.
1. Detachment
1) Perform work of item
1
.
2) Remove the front cabinet, and put it down so
that fan guard side directs downward.
Perform work on a corrugated cardboard,
cloth, etc. to prevent flaw to the product.
3) Remove the hooking claws by pushing minus
screwdriver according to the arrow mark in the
right figure, and remove the fan guard.
2. Attachment
1) Insert claw of the fan guard in the hole of the
air outlet panel.
Push the hooking claws (5 positions) by hands
and fix the claws.
After all the attaching works are complected,
check that all the hooking claws are fixed to
the specified positions.
8
Fan guard
To Next Page
Loading...
