Toshiba RAS-M14GAV-E - Page 130

Appendix-7
Appendix
Fuse
Fuse holde
r
Thermostat
Th
e
rmo
s
t
a
t
fixin
g
plat
e
P-sha
p
e clam
p
Pow
e
r
c
or
d
C
ord heate
r
* Trans
p
arent
L
s
i
de
Close-end connector
insulation ta
pe
D
e
l
e
t
e
Side cabinet
(
L
)
No.
2-4
2-5
Photo / Explanatory diagram Procedure
Rework the side cabinet (L) to remove part of it.
The area to be removed is indicated by the shaded lines
in the left figure.
After removing part of the side cabinet (L), deburr the
edges of the side cabinet (L).
Perform end process and bundling of each cable.
Using fixing screws (Self-tapping screw type-B Ø3.5 ×
6mm), fix the thermostat to the thermostat fixing plate.
Perform end process for various lead cables and connect
them according to the wiring diagram.
Attach #250 Faston and UL-approved sleeves each to
the end of lead cables which are connected to the
thermostat.
Using insulation tape, apply protective measures to the
connected parts by the close-end connectors.
Using P-shape clamp and the screws (Self-tapping
screw type-B Ø4 × 8mm), fix the power cord to the
thermostat fixing plate.
When the power cord size does not match with P-shape
clamp, procure the most appropriate one at the local site.