If there is other indoor unit to be changed, repeat
procedure 2 to 5 to change the setup.
When the above setup has finished, push
to
select the indoor unit No. before change of setup,
specify CODE No. [12], [13], [14] in order with temp.
setup
buttons, and then check the changed
contents.
Address change check before change:
[3-3-1] → After change [2-2-2].
Pushing
button clears the contents of which setup
was changed.
(In this case, procedure from 2 is repeated).
Indoor unit No. before setup change is displayed
Procedure 7
After check of the changed contents, push
button, the display disappears and the status
becomes the usual stop status. (When pushing
button the operation from the remote controller is not
accepted for approx. 1 minute).
• If the operation from the remote controller is not
accepted even 1 minute or more passed after
pushing
button, it is considered that the
address setup is incorrect.
In this case, the automatic address must be set
again set up.
Therefore repeat procedure of the setup change
from procedure 1.
To recognize the position of the corresponding
indoor unit though the indoor unit No. is known.
Check the position during operation stop.
(Be sure to stop operation of the set).
Procedure 1
Push simultaneously
+ buttons for 4
seconds or more.
After a while, the display part flashes and the display
appears as shown below.
In this time, the position can be checked because fan
of the indoor unit operate.
• For the group control, the indoor unit No. is
displayed as [
] and fans of all the indoor
units in the group control operate.
Check the display CODE No. is [01].
• When the CODE No. is other than [01], push
button to erase the display and repeat procedure
from the first step.
(After pushing
button, operation of the remote
controller is not accepted for approx. 1 minute).
Procedure 2
In the group control, every pushing
button,
the indoor No. in the group control is displayed in
order.
In this time, the position of the indoor unit can be
confirmed because the only fan of the selected
indoor unit operate.
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit).
Procedure 3
After confirmation, push
button to return the mode
to the usual mode.
When pushing the button, the display disappears
and the status becomes the usual stop status.
(When pushing button the operation from the
remote controller is not accepted for approx. 1
minute).
(* Display changes according to
the model No. of indoor unit.)
To Next Page
Loading...
