To Next PageTo Next Page
Need help?Do you have a question about the Toshiba RAV-SP1404AT8-E and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Noise Level (Indoor) | 47 dB(A) |
| Noise Level (Outdoor) | 54 dB(A) |
| Type | Split System |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (Cooling) | 3.5 |
Details about the outdoor unit and Super Digital Inverter series.
Defines qualifications and knowledge required for installation and service personnel.
Explains safety indications and illustrated marks used in the manual.
Provides essential safety guidelines for handling the air conditioner.
Highlights safety measures specific to R410A refrigerant.
Details the process and materials for installing refrigerant piping.
Provides detailed technical specifications for indoor units.
Detailed diagrams of the outdoor unit's external construction.
Illustrates the wiring connections for the outdoor unit.
Lists specifications for electrical components in the outdoor unit.
Crucial safety measures for R410A installation and servicing.
Details on installing refrigerant piping, materials, and joints.
Procedure for recovering refrigerant from the unit for relocation or service.
Details on the control system and circuit configurations of the outdoor unit.
Explains the operation and control logic of the Pulse Motor Valve.
Describes the control mechanism for discharge temperature.
Provides an overview of common troubleshooting steps and checks.
Explains how to interpret error codes and symptoms for diagnosis.
Details how to use the remote controller for monitoring system status.
A comprehensive list of outdoor unit check codes and their causes.
Step-by-step guide for setting unit addresses and group configuration.
Details on setting addresses and managing group control operations.
Wiring diagrams and instructions for connecting remote controllers.
Procedure for manually setting unit addresses via the remote controller.
How to check the position and address of indoor units.
An overview of the steps involved in replacing the compressor.
Important preliminary information and instructions.
Comprehensive safety guidelines for installation and operation.
Specific safety measures to be followed during installation.
Lists necessary tools and equipment for R410A installation.
Guidelines and specifications for refrigerant piping.
Detailed procedures and guidelines for refrigerant piping.
Procedure for conducting a test run after installation.
Instructions for using existing refrigerant pipes for new installations.
Essential conditions for reusing existing refrigerant pipes.
Cases where existing pipes should not be reused.
