What to do if my Toshiba RBM-A201UPVA-E safety contact has trouble?
If you are experiencing safety contact issues with your Toshiba Air Conditioner, inspect the contact at terminals DI1 / DI1. If the contact is open, check code P10 is generated. If the contact is not in use, ensure a bridge connection is installed on the terminals DI1 / DI1.
What to do if my Toshiba Air Conditioner shows an external trouble?
If your Toshiba Air Conditioner indicates an external issue, check the fan's operation monitoring at terminals DI2 / DI2. If this contact is closed, the check code L30 will be generated.
What to do if my Toshiba RBM-A201UPVA-E shows TA sensor trouble?
If your Toshiba Air Conditioner displays a TA sensor issue, check the connection of the TA sensor connector and wiring. Also, check the resistance characteristics of the TA sensor and inspect the indoor P.C. board for any problems.
What causes an incompatible group combination of indoor units in a Toshiba Air Conditioner?
An incompatible group combination of indoor units in your Toshiba Air Conditioner may be caused by incorrect model matching or a problem with the indoor P.C. board. Check the indoor units' model names and inspect the indoor P.C. board for any issues.
What causes a duplicated master remote controller issue in Toshiba Air Conditioner?
A duplicated master remote controller issue in your Toshiba Air Conditioner occurs when two remote controllers are set as the master. Check the remote controller inter-unit tie cable (A/B).
General| Brand | Toshiba |
|---|---|
| Model | RBM-A201UPVA-E |
| Category | Air Conditioner |
| Language | English |
Procedure for selecting AHU/DX COIL equipment using a flowchart.
Guidance on selecting the appropriate DX COIL design based on AHU mode.
Guidelines for the proper installation of the DX controller.
Instructions for connecting temperature sensors to the DX COIL.
Instructions for installing the Dx-valve KIT.
To Next Page
