44
CONTROLS AND FEATURES
English
To cancel searching for the AP:
Press
RETURN
while searching for the AP. A message
will appear; then, press
C
or
c
to select
Yes
and press
OK
.
Assisted Setup
a
In the
PREFERENCES
menu, highlight
Network Setup
and press
OK
.
b
Press
B
or
b
to highlight
Wireless Setup
, and press
OK
.
c
Press
B
or
b
to highlight
Assisted Setup
, and press
OK
.
d
Press
B
or
b
to select the desired AP and press
OK
.
NOTE:
Check the MAC address on the label of the AP
or in the manual, and select your AP.
e
Highlight
Security Key
and press
OK
. The Software
Keyboard window will appear.
f
Input the Security Key by using the Software Keyboard
(
see page 47
). To save your setting, press the
BLUE
button.
NOTE:
• The Security Key must adhere to these conditions:
- TKIP/AES: 8-63 ASCII or 64 Hex characters
- WEP: 5 or 13 ASCII or 10 or 26 Hex characters
• There is only one key ID to set for WEP encryption.
g
Highlight
Done
, and then press
OK
.
NOTE:
If
Network Name
is not displayed, see step 4
and 5 in
Manual Setup
below to set
Network Name
before pressing
Done
.
NOTE:
Settings are not saved if
RETURN
is pressed before
Done
is selected.
Manual Setup
a
In the
PREFERENCES
menu, highlight
Network Setup
and press
OK
.
b
Press
B
or
b
to highlight
Wireless Setup
, and press
OK
.
c
Press
B
or
b
to highlight
Manual Setup
, and press
OK
.
d
Press
B
or
b
to highlight
Network Name
, and press
OK
. The Software Keyboard window will appear.
e
Input the Network Name by using the Software
Keyboard (
see page 47
). To save your setting, press the
BLUE
button.
f
Press
B
or
b
to highlight
Authentication
, and then
press
C
or
c
to select
Open System
,
Shared Key
,
WPA-PSK
or
WPA2-PSK
.
g
Press
B
or
b
to highlight
Encryption
, and then press
C
or
c
to select
None
,
WEP
,
TKIP
or
AES
.
NOTE:
• Certain encryption types are only compatible with
specific authentication types.
- When Authentication is Open System, only WEP or
None is compatible.
- When Authentication is Shared Key, only WEP is
compatible.
- When Authentication is WPA-PSK or WPA2-PSK,
only TKIP or AES is compatible.
• When incompatible Authentication/Encryption
pairings are detected, a warning message will be
displayed, and no connection attempt will be made
until the incompatibility is resolved.
• There is only one key ID to set for WEP encryption.
h
Press
B
or
b
to highlight
Security Key
, and press
OK
.
i
Input the Security Key by using the Software Keyboard
(
see page 47
). To save your setting, press the
BLUE
button.
NOTE:
This item is grayed out when
Encryption
is
None
.
j
Highlight
Done
, and then press
OK
.
NOTE:
When
Encryption
is
None
, a message will
appear. Press
C
or
c
to select
Yes
and press
OK
.
NOTE:
Settings are not saved if
RETURN
is pressed before
Done
is selected.
Enhanced 11n
When
Enhanced 11n
is set to
On
, these features are
available.
• Dual Channel (40MHz)
• GF (Green Field)
NOTE:
In addition, some other optional 11n features will be
enabled.
a
In the
PREFERENCES
menu, highlight
Network Setup
and press
OK
. Highlight
Wireless Setup
and press
OK
.
b
Press
B
or
b
to highlight
Enhanced 11n
, and then
press
C
or
c
to select
On
.
To Next Page
Loading...
