Toshiba REGZA AV Digital Series - General Information and Settings; Auto Tuning for New Services; Programme Selection and On-Screen Info; Sound Controls and Input Selection

9
How to: add new services using Auto tuning, select programme positions and information, use the sound
controls, select DTV, ATV and external equiment.
General information
Volume
Press
j
—–
or
j
+
to adjust the volume.
Sound Mute
Press
k
once to turn the sound off and again to cancel.
Sound Controls
Input Selection
1
At any time by pressing
B
a list will appear on
screen showing modes and all stored external
equipment. Use
e and f to highlight and OK
to select.
For explanation of inputs please see specification page.
SETUP
Menu Language English
Country United Kingdom
Ant/Cable In Antenna
Auto Tuning
ATV Manual Tuning
DTV Manual Tuning
DTV Settings
AV Connection
Use
z
or
x
to select DTV then press e to select
Start Scan, press OK to start Auto tuning.
The television will start to search for all available
DTV stations.
You must allow the television to complete
the search.
When the search is complete the Auto Tuning
screen will display the services found.
Use
e or f to move through the list to select a
channel then press OK to view.
Auto Tuning
1
2
Press MENU and use
z
or
x
to select SETUP.
Use
e to highlight Ant/Cable In and then
z
or
x
to select Antenna or Cable.
Use
e to highlight Auto Tuning. Press OK.
A screen will appear warning that previous
digital channels and settings will be deleted.
2
3
Auto tuning will completely re-tune the television and can
be used to up date the channel list.
It is recommended that DTV Auto tuning is run
periodically to ensure that new services are added.
All current programmes and settings, i.e. favourites and
locked programmes, will be lost.
Auto Tuning
Previous settings will be lost! Press EXIT for
no change. Press OK to start Auto tune.
Tuning Mode DTV and ATV
Start Scan
To select a programme position use the numbered
buttons on the remote control.
Programme positions can also be selected using PP and
P Q.
To revert to the previous programme position press
RETURN .
To display on-screen information i.e. programme position,
channels, stereo/mono signal, signal strength, date and
time, press . Press again to cancel. The information
shown will vary depending on whether the television is in
DTV or ATV mode.
Press ATV/DTV at any time to select between ATV, DTV
Radio, DTV Data and DTV modes.
Selecting Programme Positions
i
+
Inputs
TV
B
1
B
2
B
3C
HDMI1
HDMI2
HDMI3
HDMI4
PC
Qpg