Satellite A210/Satellite Pro A210 xxi
Notes for Users in Australia and New Zealand
Modem warning notice for Australia
Modems connected to the Australian telecoms network must have a valid
Austel permit. This modem has been specifically configured to ensure
compliance with Austel standards when the country/region selection is set
to Australia.
The use of other country/region setting while the modem is attached to the
Australian PSTN would result in your modem being operated in a non-
compliant manner. To verify that the country/region is correctly set, enter
the command ATI which displays the currently active setting.
To set the country/region permanently to Australia, enter the following
command sequence:
■ AT%TE=1
■ ATS133=1
■ AT&F
■ AT&W
■ AT%TE=0
■ ATZ
Failure to set the modem to the Australia country/region setting as shown
above will result in the modem being operated in a non-compliant manner.
Consequently, there would be no permit in force for this equipment and the
Telecoms Act 1991 prescribes a penalty of $12,000 for the connection of
non-permitted equipment.
To Next Page
Loading...
