4.12 Display assembly 4 Replacement Procedures
Satellite A40 Maintenance Manual (960-458) 4-35
3. Turn the computer face up and open the display.
4. Remove the following screws securing the display assembly.
• M2.5×6B FLAT HEAD screw ×2
5. Disconnect the LCD cable from the connector PJ5600 on the system board.
6. Disconnect the speaker cables from the connectors PJ6001 (blue) and PJ6002 (red) on
the system board.
7. Disconnect the panel sensor cable from the connector PJ3302 on the system board.
M2.5
6B FLAT HEAD
Speaker cable (blue)
Panel sensor cable
Speaker cable (red)
Figure 4-20 Removing the display assembly (2)
To Next Page
Loading...
