4.14 LED board 4 Replacement Procedures
Satellite A40 Maintenance Manual (960-458) 4-41
Installing the LED board
The following describes the procedure for installing the LED board (See Figure 4-23).
1. Connect the LED cable to the LED board and to the connector PJ9500 on the system
board.
NOTE: When connecting the LED cable, the bent portion of the cable must be connected
to the connector on the LED board.
2. Fix the LED board to the system board with the following screw.
• M2.5×6B FLAT HEAD screw ×1
To Next Page
Loading...
