4 Replacement Procedures 4.23 Display mask/LCD unit/FL inverter
4-58 Satellite A40 Maintenance Manual (960-458)
3. Remove the following screw fixing the FL inverter.
• M2×5C S-FLAT HEAD screw x1
4. Peel off the insulator adhered to the FL inverter.
5. Disconnect the FL cable under the insulator and HV cable from the FL inverter.
6. Remove the following screws fixing the LCD unit.
• M2×5C S-FLAT HEAD screw x4
7. With the bottom edge of the LCD unit on the display cover, lift the top edge of the LCD
unit.
8. After peeling off the glass tape, disconnect the LCD cable from the connector on the back
of the LCD. Remove the LCD unit.
To Next Page
Loading...
