User’s Manual 4-27
Operating Basics
■ When you back up a DVD disc, be sure that the source drive supports
recording to DVD-R, DVD-R (Dual Layer), DVD-RW, DVD+R, DVD+R
(Double Layer) or DVD+RW media - if this is not the case then the
source disc might not be backed up correctly.
■ When you back up a DVD-R, DVD-R (Dual Layer), DVD-RW, DVD+R,
DVD+R (Double Layer) or DVD+RW disc, be sure to use the same type
of disc.
■ You cannot partially delete any data written to a CD-RW, DVD-RW or
DVD+RW disc.
Data Verification
To verify that data has been written or rewritten correctly to a data
CD/DVD/BD you should follow the steps below before you begin the
write/rewrite process:
1. Select Settings for Each Mode → Data Disc in the Setting menu.
2. Display the setting dialog box by one of the following two steps:
■ Click the Recording settings button ( ) for writing on the main
toolbar in the Data Disc mode.
■ Select Setting for Each Mode → Data Disc in the Setting menu.
3. Mark the Verify written data check box.
4. Select File Open or Full Compare mode.
5. Click the OK button.
How to learn more about TOSHIBA Disc Creator
Please refer to the Help files for additional TOSHIBA Disc Creator
information.
■ Opening the TOSHIBA Disc Creator Manual
Start → All Programs → TOSHIBA → CD&DVD Applications → Disc
Creator Help
When Using Corel DVD MovieFactory for TOSHIBA
How to make a Labelflash DVD
Simplified steps for making a Labelflash DVD:
1. Insert a Labelflash disc in optical disc drive.
2. Launch Corel Label@Once (the operation varies depending on the
models you purchased):
■ Click Start → All Programs → DVD MovieFactory for TOSHIBA
→ DVD MovieFactory Launcher. Click Create Disc Label.
■ Click Start → All Programs → Corel Label@Once → Corel
Label@Once.
3. Click the General tab.
Set PRINTING SIDE for underside.
To Next Page
Loading...
Need help?
General